Shaker
Modern flat-panel
Two-tone cabinets
KraftMaid
Cambria quartz
Butcher block
Open shelvingFree design consultation - KraftMaid and Wellborn cabinet lines, Cambria and Silestone surfaces, and every tier from refacing to full custom laid out side by side
Trusted Cabinet Installation for Henderson Homeowners
Cabinet installation in Henderson goes wrong most often at the seams: a box that doesn’t sit plumb against a wall that was never straight, doors that drift out of alignment within a season, a filler piece cut wide enough to hide a gap you’ll notice every morning. That’s the problem a homeowner can’t see until the boxes are on the wall. We install cabinetry from KraftMaid and Wellborn, brands that carry their own manufacturer warranties, and our technicians have up to 14 years of experience setting boxes, leveling frames, and hanging doors that close the way they did the day they went up. We’re kitchen-only, so cabinet work is the whole job, not a sideline. Call (888) 397-6875.
What Our Cabinet Installation Service Includes
Cabinet Removal and Room Prep
The old cabinets come out before anything new goes in, and that’s where most hidden problems surface. Removing existing boxes lets us check the wall behind them, the floor under the cabinet line, and whether the room was ever built square. You need this step when you’re replacing a dated cabinet run, opening up a wall of uppers for a different layout, or knocking a soffit out to get full-height storage. We pull the old cabinetry, protect the floors, and tell you plainly if the wall condition changes the plan before we hang anything.

Base Cabinet Installation
Base cabinets carry the countertop, so they have to be level, plumb, and tied together as one unit rather than a row of separate boxes. A high spot under one base can telegraph through a quartz slab later, and a low spot makes the whole run look wavy. You need base installation whenever you’re changing the footprint of the kitchen or replacing water-damaged cabinets under the sink. We shim and scribe each base, screw the run together, and check the line before the countertop goes on top.

Wall Cabinet and Full-Height Installation
Wall cabinets hang on the studs, and how well they line up at the top and bottom decides whether the kitchen looks custom or cobbled together. Full-height uppers that run to the ceiling need a soffit removed or a new frame, which is a different job than swapping like for like. You need this when you want more storage, a cleaner line, or taller upper doors. We locate the studs, set the cabinet line to a single reference, and hang the doors after the boxes are square so the reveals stay even.

Cabinet Installation
This is the core of the trade: leveling, joining, shimming, and anchoring cabinets so the doors and drawers work smoothly for years. You need cabinet installation when you’re redoing a kitchen’s layout or moving into new boxes in an existing space. We handle the KraftMaid and Wellborn lines, dry-fit the layout, and set the boxes so the countertop surface and the door reveals line up the way they should. Our technicians have up to 14 years of experience, and it shows in the details.
Cabinet Hardware and Door Alignment
Handles, pulls, knobs, soft-close hinges, and door adjustment are the finishing pieces that make a cabinet run feel right. Badly aligned doors are one of the most common complaints after a cheap install, and it’s almost always a hinge adjustment, not a defect. You need this step if doors won’t close flush, drawers pull crooked, or you’re adding hardware to a new run. We hang and align every door and drawer front, install the hardware, and adjust the hinges before we call the job done.
Countertop and Fixture Coordination
Cabinets don’t live alone in a kitchen: the sink cutout, the faucet position, and the slab overhang all depend on the cabinet line being right first. You need this coordination when you’re doing cabinets and countertops together, which is most of the jobs we see. We measure the installed cabinets for the countertop template, and the same team handles the Kohler, Moen, and Blanco sink and faucet installs, so nothing falls into the gap between two subs.
Styles & brands we work with
- Shaker
- Modern flat-panel
- Two-tone cabinets
- KraftMaid
- Cambria quartz
- Butcher block
- Open shelving
Brands We Service for Cabinet Installation
We install KraftMaid cabinetry because it’s a line with real quality standards and a manufacturer-backed limited lifetime warranty behind the boxes. Knowing a brand means knowing where its frames sit, how its drawer hardware behaves, and which finishes hold up best in a kitchen with strong afternoon sun. We install Wellborn for the same reason: its construction and door styles suit homeowners who want a step above builder-grade without guessing what they’re buying.
The surface brands matter too, because cabinetry and countertops are decided together. We work with Cambria, an American-made, family-owned quartz line, Silestone, and Caesarstone, so you can compare three premium surfaces under one roof instead of driving between suppliers. Whether you’re set on KraftMaid, Wellborn, or a look that Cambria or Silestone best completes, we can help you get the whole kitchen coordinated.
Signs You Need Cabinet Installation Right Now
- Doors that won’t stay aligned. If cabinet doors rub, warp, or swing open on their own, the hinges are worn or the boxes were never set plumb. It’s a small annoyance now, but it usually means the install itself needs attention, not just a new hinge.
- Sagging or separated shelves. A shelf that bows under normal weight or a bottom panel pulling away from the sides is a sign the cabinet has lost its structural integrity. Once the box gives, the door and drawer hardware follow, so it’s worth addressing before it gets worse.
- Water damage under the sink. Soft, swollen particleboard or a musty smell inside a base cabinet means a leak has been soaking the box. Cabinet material that’s been wet and swollen doesn’t recover, and it’s also the healthiest time to find the leak’s source.
- Drawers that stick or come off their tracks. Sticking drawers can be a track problem, but when it happens across a run of cabinets, the boxes usually aren’t square. New installation with properly shimmed frames is often the only fix that holds.
- Cabinets pulling away from the wall. A visible gap at the top or side of a cabinet run, especially one that grows over time, means the anchoring has failed. It’s a safety issue as much as a cosmetic one, so it deserves a look.
Our Cabinet Installation Process – Step by Step
- 1
Free in-home estimate and layout review. We walk the kitchen, measure the existing space, and talk through what you want the cabinets to do. You’ll get a written line-item quote so you know exactly what’s included and what isn’t before anything gets ordered.
- 2
Brand and finish selection. We walk you through the KraftMaid and Wellborn lines plus the Cambria, Silestone, and Caesarstone surfaces that go with them. Picking cabinets and countertops together at the same time is how you avoid the change-order surprises that come from choosing them in isolation.
- 3
Cabinet order and staging. Once the layout and finishes are locked, the cabinetry is ordered and checked against the plan on arrival. We confirm the door styles, drawer configurations, and filler sizes match what was measured.
- 4
Removal, prep, and installation. Old cabinets come out, walls and floors get checked, and the new boxes go in level, plumb, and screwed together as one run. Our technicians set the bases, hang the uppers to a single reference line, and check the door reveals before the countertop is templated.
- 5
Hardware, alignment, and final walkthrough. Doors and drawers get adjusted, hardware goes on, and we walk the kitchen with you to make sure every door closes the way it should. The written estimate sets the final price, so there are no surprises at the end.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Cabinet Installation Cost in Henderson?
Cabinet installation in Henderson typically runs $3,720 – $12,090, depending on the size of the kitchen, the cabinet line, and whether you’re replacing like for like or redoing the layout. A straightforward base and wall cabinet swap in a smaller kitchen sits near the bottom of that range. A larger kitchen with full-height uppers, a new island, and interior accessories lands toward the top. If you’re pricing the whole kitchen at once, a full kitchen remodel runs $13,020 – $41,850, and a small kitchen remodel runs $8,370 – $18,600.
What moves the price most is the cabinet line and door style, the number of boxes and drawers, and whether the wall or floor needs prep work once the old cabinets are out. Choosing KraftMaid or Wellborn is part of that decision, and so is the surface above the cabinets: countertop installation in Henderson runs $1,860 – $6,045, which is why spec’ing cabinets and countertops together helps you see the real project cost. The way to avoid overpaying is to get a written line-item estimate that separates cabinets, labor, and any prep work, so you can see exactly what you’re paying for. A free estimate covers the measuring, the layout review, and the written quote, and the written estimate sets the final price.
Cabinet Installation Near Henderson – Our Service Area
We handle cabinet installation across Henderson and the surrounding valley, including Whitney, Paradise, Winchester, Enterprise, and Boulder City, plus Las Vegas, North Las Vegas, Spring Valley, Summerlin, Sunrise Manor, and Sandy Valley. We also cover cabinet installation in nearby Paradise and cabinet installation in Whitney without a separate call. Wherever you are in the valley, the first step is a free in-home estimate so we can measure your kitchen for real.
Serving Henderson, NV – Our Local Coverage Area
We serve Henderson and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Cabinet Installation in Henderson
Cabinet installation is the process of removing old cabinetry, preparing the walls and floor, and setting new base, wall, and full-height cabinets so they’re level, plumb, and joined into a single, solid run. It includes shimming, anchoring to studs, hanging doors, installing hardware, and aligning drawers so everything closes evenly. It’s different from a cosmetic refresh because the boxes are being replaced, not just refaced or repainted. In Henderson, most cabinet installs are part of a larger kitchen remodel, but a standalone cabinet swap is a job we handle on its own.
A typical cabinet installation takes about two to four days for the boxes and doors once the new cabinetry is on site, with the kitchen fully usable again after the countertop goes in. Larger kitchens with full-height uppers, an island, and interior accessories take longer, and special-order door styles add lead time before installation can start. Kitchen-only work means the schedule is built around one trade, so you’re not waiting for a generalist crew to finish another job first. Call (888) 397-6875 for a timeline based on your kitchen.
Cabinet installation in Henderson typically runs $3,720 – $12,090, depending on kitchen size, the cabinet line, and whether the layout changes. A simple replacement sits at the low end, and a larger kitchen with full-height uppers and new hardware sits near the top. The written estimate sets the final price, and we don’t do change-order surprises once work starts. Call (888) 397-6875 for an exact quote, and the estimate is free.
Yes, we install KraftMaid and Wellborn cabinetry, and both carry their own manufacturer-backed limited lifetime warranties on top of the installation itself. We’re familiar with how the boxes are built and how the door styles sit, which matters when they’re being set alongside Cambria, Silestone, or Caesarstone countertops. If you’re weighing the two lines, our estimate walks you through the differences before you commit. Call (888) 397-6875 to talk through cabinet options.
We can sometimes handle a same-day cabinet install on smaller jobs where the cabinets are already on site, but a full kitchen cabinet install is planned ahead so the order, prep, and template steps line up. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening. If a cabinet fails and you need a fast look, call and we’ll find the soonest slot.
The cabinetry itself carries the manufacturer’s warranty, and KraftMaid and Wellborn both back their lines with a limited lifetime warranty. Our own installation workmanship is also covered, and the details are spelled out in your written estimate so you know exactly what’s protected. Sinks and faucets from Kohler, Moen, and Blanco carry their own product warranties, which protects you beyond the installation. Call (888) 397-6875 with questions about coverage.
Clear the countertops and the cabinets that are coming out, remove what’s stored inside, and plan to keep the kitchen out of use during the install days. It helps to move small appliances and pantry items to another room in advance, and to make sure the path to the kitchen is clear for cabinet delivery. If the countertops are being templated, expect that step to happen after the boxes are set, which adds a short gap before the sink and faucet go back in. Call (888) 397-6875 if you’re unsure what to move and what we’ll handle.
Schedule Your Cabinet Installation Service in Henderson Today
If you’re ready to talk cabinets, call (888) 397-6875 for a free estimate. We walk your kitchen, measure the space, and put together a written line-item quote covering KraftMaid or Wellborn cabinetry and the Cambria, Silestone, or Caesarstone surface above it. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. No obligation, and the written estimate sets the final price.
Written by the team at Kitchen Remodeling Henderson.